How to send MIDI message to external device?

For users of legacy Steinberg Cubase software
Post Reply
jer2010
New Member
Posts: 1
Joined: Thu Dec 16, 2010 11:14 am
Contact:

How to send MIDI message to external device?

Post by jer2010 » Thu Dec 16, 2010 11:46 am

Hi

Im using Cubase SE3. My setup works grate, when recording and playing MIDI. I have several synths in my setup assign to different channels. My question is really simple: How can I transmit a MIDI message to a particular synth enabling it to start the arpigator and when to stop it?
The synth I want to control is an Korg Triton Extreme. I use a particular program in "combi mode" that has an arp/rythm section as part of the total sound setup. Manually I can start the arp/rythm section by pressing and repressing a start/stop button. But I want my Cubase to this for me, so I dont have to do this manually.
One thing that works is that when my cubase song start and my synth start/stop buttom is "armed", red light, it starts the arp/rythm as soon as the first midi notes are played. This is ok sometimes but in other songs, I want to control when it shall start. At the end of the song, the synth will continue to play the arp/rythm part until I press the start/stop button. Again, I want to avoid this, and let Cubase due this...
Thanks in advance!

User avatar
Chris Dobbs
Member
Posts: 690
Joined: Wed Dec 15, 2010 9:21 pm
Contact:

Re: How to send MIDI message to external device?

Post by Chris Dobbs » Thu Dec 16, 2010 4:12 pm

Hello,

It sounds like the Arp on/off control may be happening with either CC data or sysex data. Here are the steps I use to figure out what data channel an event is happening on.

Start a new empty project with a MIDI track. Put the MIDI track in record enable and press record. Play middle C for a whole note, then press the controller you are wanting to see (ARP on/off button). Press stop.

Now double-click on the MIDI event that was recorded. At the bottom left where it currently says "Velocity", click on that pull-down menu. You should see Velocity listed with an Asterisk (*), and you should also see another item with an * after it. The * means that there is data on that channel. Select the other item with the *, and you should see the data happening at the same time as the ARP on/off button.


One note: If the data is coming through Sysex, you need to turn off the Sysex filtering. Go to Preferences, MIDI Filter, and uncheck "Sysex". I hope this info helps.
Chris Dobbs
Application Specialist
Steinberg US Support

Check out Steinberg on YouTube, Twitter and Facebook!

Post Reply

Return to “Older Cubase versions”

Who is online

Users browsing this forum: Google [Bot] and 4 guests