No audio output in Cubase 8 Elements w/ Apogee Symphony I/O USB

Use this forum for an overview of collected issues and to report new ones.
Post Reply
bluevoodoo
New Member
Posts: 2
Joined: Wed Apr 11, 2018 7:08 am
Contact:

No audio output in Cubase 8 Elements w/ Apogee Symphony I/O USB

Post by bluevoodoo » Wed Apr 11, 2018 7:13 am

Hi,

I have recently bought an Apogee Symphony I/O MkI interface and the problem is even though everything is set up correctly (there is output from system sounds), I can get no output from Cubase. The device is recognized, all inputs and outputs are present in the VST Connections but there is no output, no meters are showing any signal when I hit playback. What I found out is that in the Apogee Maestro 2 SW the clock source is set to internal but in Cubase I cannot set it like that, it always goes back automatically to a dash below "internal" in the device setup.

bluevoodoo
New Member
Posts: 2
Joined: Wed Apr 11, 2018 7:08 am
Contact:

Re: No audio output in Cubase 8 Elements w/ Apogee Symphony I/O USB

Post by bluevoodoo » Tue Apr 24, 2018 7:55 pm

Any suggestions on how to solve this? (using OSX version 10.13.3)

Post Reply

Return to “Issues”

Who is online

Users browsing this forum: No registered users and 1 guest