Page 1 of 1

CI1 separating inputs on OSX/Mainstage

Posted: Sat Jun 02, 2012 3:22 pm
by authoreyes
Hi,

Sorry if this is a stupid question or not possible, but I am using the CI1 with Mainstage 2 on OSX.

When I configure a song, I create a new channel strip, with has an input source of input 1-2 (which is the correct CI1 device)

I want to be able to use this live, so I have guitar in line 1, vocals in line 2 plugged into the CI1.

In Mainstage, I have an insert on channel strip 1 of Peavey Revalver for my guitar pre-amp/effects, but it applies the same effect to the mic in line 2.

Is there a way to separate the in's as 2 separate channel strips so I don't apply Revalver to the mic in?

Re: CI1 separating inputs on OSX/Mainstage

Posted: Sat Jun 02, 2012 9:41 pm
by authoreyes
Never mind,

Stupid question...Figured it out...The channel strip one was set to stereo - setting to mono and adding a second to take the 2nd input worked like a charm.