Reverb send and direct monitoring

All about Steinberg's AXR4 audio interface
Post Reply
doktari
New Member
Posts: 48
Joined: Thu Dec 01, 2011 3:49 am
Contact:

Reverb send and direct monitoring

Post by doktari »

Maybe I'm missing something. Could someone explain how to get reverb to send to the axr hardware reverb will using direct monitoring in cubase? The reverb send is up, but without the monitor fader up in dsp console, nothing gets sent because the send is post fader
Windows 10
Cubase pro 10.5

doktari
New Member
Posts: 48
Joined: Thu Dec 01, 2011 3:49 am
Contact:

Re: Reverb send and direct monitoring

Post by doktari »

Figured it out. So when using the control room, you need to set up a dummy output so the AXR menu shows up in Cubase.

In the AXR mixer 'settings' menu, the reverb post monitor send has to be set to the same output as the dummy output. I wish this was more intuitive.
Windows 10
Cubase pro 10.5

Aldersyde
Member
Posts: 337
Joined: Sat Sep 14, 2013 2:27 pm
Contact:

Re: Reverb send and direct monitoring

Post by Aldersyde »

doktari wrote:
Mon May 25, 2020 10:28 pm
Figured it out. So when using the control room, you need to set up a dummy output so the AXR menu shows up in Cubase.

In the AXR mixer 'settings' menu, the reverb post monitor send has to be set to the same output as the dummy output. I wish this was more intuitive.
Just ran into the same exact issue yesterday and took several hours to come up with the same solution.

Post Reply

Return to “Steinberg AXR”

Who is online

Users browsing this forum: No registered users and 1 guest