Page 1 of 1

Cycle recording question. Answer + Demo

Posted: Tue Mar 26, 2019 5:26 pm
by fenderchris
I'm trying to do a tight punch in and out in Cycle mode and would like each cycle to play a couple of bars lead in before punching in to record.

Is this possible?

I've tried using preroll and markers, but once the cursor is within the punch in and out points it only cycles between those two points. It doesn't seem possible to get it to play a bit before the punch in point in each cycle.

Re: Cycle recording question.

Posted: Wed Apr 03, 2019 4:36 pm
by fenderchris
To answer my own question, it is possible in N8.

Punch in/out points can now be set independently from the left/right locators. This means that while cycling between the left/right locators, the punch in/out points can be set within the locator range.

A small but significant improvement.

Re: Cycle recording question.

Posted: Wed Apr 03, 2019 5:09 pm
by Fredo
Damn ... you are good at this!

Re: Cycle recording question.

Posted: Wed Apr 03, 2019 11:12 pm
by fenderchris
Fredo wrote:
Wed Apr 03, 2019 5:09 pm
Damn ... you are good at this!
If you are talking about answering my own questions, I have to agree with you.

Re: Cycle recording question.

Posted: Thu Apr 04, 2019 7:45 am
by Fredo
:)

Re: Cycle recording question.

Posted: Thu Apr 04, 2019 9:07 am
by Soderlund
Hi fenderchris! How did you do it?
Micke.

Re: Cycle recording question.

Posted: Thu Apr 04, 2019 10:43 am
by fenderchris
Soderlund wrote:
Thu Apr 04, 2019 9:07 am
Hi fenderchris! How did you do it?
Micke.
Example:

Set Left Locator to bar 4
Set Right Locator to bar 7
Click on the little Padlock icon. This will unlock the Punch In/Out points from the Left/right Locator points, allowing them to be set differently.

Here is a little video demo:
Punch In Loop.gif
(1.77 MiB) Not downloaded yet