Page 1 of 1

estimating a custom effect

Posted: Wed Jun 19, 2019 1:59 am
by fractalbase
effect: compressor/Expander
presets: "reduce peaks"

This effect attempts to lower the high spikes and peaks with soundwaves and attempt to focus on normalizing volume.
Repeat this process with "Normalize", "Reduce Peaks", "Normalize".

Any way to recreate that in the Steinberg tool set (aka WaveLab Elements 9).

any suggestions?

Re: estimating a custom effect

Posted: Wed Jun 19, 2019 7:13 pm
by fractalbase
I should mention the custom effect described is from GoldWave.

Re: estimating a custom effect

Posted: Wed Jun 19, 2019 7:47 pm
by bob99
fractalbase wrote:
Wed Jun 19, 2019 1:59 am
"Normalize", "Reduce Peaks", "Normalize".
One way to do exactly that in Elements 9.5 would be:

Process - Level - Maximum

Then with the Peak Master in the Master Section with Out Ceiling < 0, press the Render in Place button on the Peak Master.

Then, Process - Level - Maximum again.

You could try that then compare to the Goldwave result and adjust the Peak Master Out Ceiling and Softness as needed.

Probably best to work on a copy of the audio file if you don't want to render.

Re: estimating a custom effect

Posted: Mon Jul 01, 2019 2:08 am
by fractalbase
Thanks for the information.

Where in the master section is the peak master?

thanks,
Chris

Re: estimating a custom effect

Posted: Mon Jul 01, 2019 2:24 am
by fractalbase
Okay I found the items in question:
https://steinberg.help/wavelab_le_plug_ ... ter_r.html
https://steinberg.help/wavelab_elements ... ing_c.html
I've set the peak master out ceiling to 0.00db, and then performed a "render in place".
But nothing changed.
Any help?
p.s. I'm still a WaveLab newbie.

Re: estimating a custom effect

Posted: Mon Jul 01, 2019 3:14 am
by bob99
fractalbase wrote:
Mon Jul 01, 2019 2:24 am
I've set the peak master out ceiling to 0.00db, and then performed a "render in place".
Out Ceiling has to be less than 0 to reduce the peaks in this particular procedure. Try Out Ceiling at -0.5, or whatever amount you want to reduce the peak(s), but it will become audible (in a bad way) at some point.

Re: estimating a custom effect

Posted: Mon Jul 01, 2019 5:08 am
by fractalbase
thanks, I figured out what I was looking for.
quick follow-up question: is there integration between WaveLav and Cubase?

Re: estimating a custom effect

Posted: Mon Jul 01, 2019 9:28 am
by bob99
fractalbase wrote:
Mon Jul 01, 2019 5:08 am
quick follow-up question: is there integration between WaveLav and Cubase?
If you mean like this
https://steinberg.help/wavelab_elements ... ing_t.html
I guess so.

Re: estimating a custom effect

Posted: Wed Jul 03, 2019 3:31 am
by fractalbase
perfect, thanks.