Page 1 of 1

Spectrum processing bug ??

Posted: Sun Apr 28, 2019 2:28 pm
by skorefish
Hello,

On page 449 of the manual one can read: "to apply spectrum processing over 60 seconds, Use rectangle Selection tool and activate master Section."

When i make a selection over 60 seconds there is simply no audio, i can not render anything... is this a bug or a setting? When i adjust the selection under 60 it all works...
What can i do.

i use the latest version of wavelab 9.5.50

Re: Spectrum processing bug ??

Posted: Sun Apr 28, 2019 5:44 pm
by PG
It's a mistake indeed. Master Section processing only works till 60 sec, while it should be able to do more.

Re: Spectrum processing bug ??

Posted: Sun Apr 28, 2019 7:20 pm
by skorefish
is there a workaround?? editing small parts leaves artefacts at the beginning and end of selection. Or is there a way to get rid of the artefacts?

The only solution i see is splitting it up in parts of less than 60 sec, losing a part at the beginning and end for the artefacts and at the end gluing it all together. Is this the way to go or is there an easier solution?

Re: Spectrum processing bug ??

Posted: Sun Apr 28, 2019 9:21 pm
by PG
What kind of spectral editing do you need for such long sections of audio?

Re: Spectrum processing bug ??

Posted: Mon Apr 29, 2019 3:11 pm
by skorefish
For example to use an external single band compressor on a verry narrow band. Say for instance waves C1 because it has negative compression.