Bug: Grouped clips do not stay grouped when moving things with ripple active

[toader]

1) Put a clip on track 1
2) Put another clip exact same length on track 2 (maybe just a copy of clip 1 for this test)
3) Put another clip on track 3 - exact same length (maybe just a copy of clip 1 for this test again)
4) Now... split the clip on track 3 into 2 separate clips.
5) Group both of the clips on track 3
6) Drag one of the clips on track 3 - and the other clip follows correctly
7) Undo so it returns where it was
8) Enable global ripple, and drag the clip on track one forward
9) BUG - both clips on track 3 do not move... only one does... Group is not functioning to keep the two clips grouped.

[PG]

Thanks for the detailed procedure, but I could not reproduce.

[bob99]

9) BUG - both clips on track 3 do not move... only one does... Group is not functioning to keep the two clips grouped.

I can get it to do this only if the clip on track 1 starts slightly later than the first clip on track 3, even by a sample. So I guess that effectively ungroups the group?

[toader]

Hmm... Maybe I didn't have them lined up perfectly... but still, that shouldn't ungroup the group should it? I can try to do a video if it helps, but yeah, I was dragging with global ripple enabled, and clips on both track one and two, AND the last clip of track 3 were moving... but the 1st clip on track 3 wasn't moving (even though it was grouped with the 2nd clip on track 3).

[PG]

You are both right, I confirm a fault.