Jumping / Stuttering / Freezing when writing automation

Post general topics related to Nuendo 7 here.
Post Reply
Junior Member
Posts: 75
Joined: Fri Feb 25, 2011 6:04 am

Jumping / Stuttering / Freezing when writing automation

Post by KMT333 »

When writing fader automation in very large files I was getting horrible freezing / jumping / stepping (call it what you will) of the timecode and timeline and the automation was updating every second or so, so it was unusable. The system would play back and read automation perfectly and this would only occur in automation write.

I found that the problem was being caused by having the Overview Line turned on in the very large project. Once I turned it off the system ran like a dream. This never used to be a problem in N6.
Nuendo 10.3, Windows 10 64 bit, I7 5960X, 32GB RAM / Ryzen 3950X, 64GB RAM / Ryzen 3900X 64GB RAM

Post Reply

Return to “General”

Who is online

Users browsing this forum: No registered users and 1 guest