Bounce AU to audio??

Post Reply
Jimmy two times
New Member
Posts: 7
Joined: Mon Jun 26, 2017 4:41 am
Contact:

Bounce AU to audio??

Post by Jimmy two times » Mon Nov 26, 2018 3:52 am

I can’t figure out how to bounce an AU track to audio. I tried routing the au audio into Cubasis with Audiobus 3, but it does t record anything. Is this impossible?

User avatar
LSlowak
Steinberg Employee
Posts: 3135
Joined: Thu Aug 08, 2013 12:36 pm
Contact:

Re: Bounce AU to audio??

Post by LSlowak » Mon Nov 26, 2018 11:18 am

Hi Jimmy two times,

Thanks for your message!
Please note that no routing setting is required to work with AU plug-ins in Cubasis.

(1) Track Freeze
- Please tap the freeze button below the instrument button on the track in the track list
This immediately creates an audio track of your AU MIDI track.

(2) Mixdown
- Please go to MEDIA/Mixdown
- Tap the "Create Mixdown" entry in the list
This immediately creates an audio track (mixdown) of your project.

Additionally, these are the steps to load an AU instrument...

- Create a MIDI track in Cubasis
- Tap the "Piano" instrument button on the track in the track list
- Choose the AU instrument from within the AU list

... the steps to load an AU effect (make sure at least one audio or MIDI track has been created)

- Select a track, where you want to add an AU effect
- Open the "Insert Effects" or "Send Effects" tab in the inspector
- Tap on an empty FX slot and choose an AU effect from the list

Hope that helps!

Best,
Lars
Lars Slowak - Project Management & Team lead Cubasis
Steinberg Media Technologies GmbH
Hamburg, Germany
Check out Steinberg on YouTube, Twitter and Facebook

Post Reply

Return to “Cubasis | Cubasis 2”

Who is online

Users browsing this forum: No registered users and 1 guest