CMC-TP Fail

This section is about Steinberg's CMC controllers
Post Reply
Rich
Junior Member
Posts: 102
Joined: Wed Dec 15, 2010 10:26 pm
Contact:

CMC-TP Fail

Post by Rich »

The "stop" button when pressed twice does not return the cursor to zero. It works fine with an empty project, but when events are in the arrange page it gets a bit jittery followed by a fail when trying to return to zero.

Anyone else seen this behavior?

-Rich

Post Reply

Return to “Steinberg CMC Series”

Who is online

Users browsing this forum: No registered users and 1 guest